Talaria MX3 and MX4 Warp 9 gearcase vent installation instructions.
Locate the gearcase vent routed from gearcase up along frame. MX4 models you will need to remove the pinch clamp if it’s still installed. To do this remove line from both clamps and release pinch clamp and the stock one way valve, slide clamp off hose.
Loosen TOP Allen bolt securing the vent clamp just enough to remove the line, before cutting gearcase vent, install Warp 9 gearcase vent system on the top clamp.
Cut gearcase vent hose to length, approximately 52mm/2inches from top of bottom clamp. Install vent hose as far as possible onto valve.
